|
|
|
Preparation Preparation,
Preparation! |
|
 |
The success of your floor depends on 3 things…
Preparation, Preparation, Preparation!
The key to success for an epoxy floor is in the skilled
preparation of your substrate floor. The surface to be coated
must be sound, clean, free of old coatings, and properly
prepared so as to have an approximately medium sand-
paper profile. Our initial preparation will be accomplished
with “dust free” mechanical shot blast equipment or
“dustless” diamond grinding in the areas not accessible
to
the shot blasting equipment. We own over a quarter million
dollars in state of the art equipment run by our dedicated
employees. |
|
We take special steps and inspection to ensure that
this procedure is done right! This is the single most
important factor in ensuring that your floor does not
fail!
In order to ensure that your new floor meets your
entire project needs; preparation may include
the following services at an up charge (cost will vary
depending on the condition of the substrate):
- Removal of existing floor
- Dust protection for clean room standard
environments
- Cove Base Detail at the walls and/or equipment
- Sloping the drains
- Fiberglass Reinforcement of joints
- Diamond Grinding
- Shot Blastings
Preparation Pictures
|
|
|
|
|
| |
What is Diamond Grinding?
A handheld grinder that has rapidly rotating diamond segment
wheels. It levels high spots on concrete floors, removes
concrete latents as well as paints and coatings and is
ideal for
prepping awkward spots. All dust and "waste"
from the job is automatically filtered through a vacuum
containing a HEPA filter which sucks up even the tiniest
particles.
What is Shot Blasting?
Shot blasting is a method used on concrete and tiled surfaces,
which prepares the surface for the application of a coating,
sealer or epoxy floor. In order for a new epoxy floor,
coating or overlay to bond correctly to a surface, it
must be clean, dry and profiled. A surface profile is
needed to provide a grip or "teeth" for the
coating to adhere to. The shot blast machine works by
propelling steel shot at a high velocity onto a surface.
This shot removes the surface layer of the concrete or
tile, taking dirt, coatings, paint or other contaminates
with it. A vacuum system in the machine pulls the debris
into a chamber where an air wash system separates the
debris from the shot. The dust free operation allows you
to shot blast in almost any area including sensitive environments
such as food processing and pharmaceutical plants. |
| |
BENEFITS:
. Removal of the top layer of concrete
. Removal of chemical contaminates
. Removal of curing agents that inhibit the bond of the
coating
. Enhances the flooring profile by increasing the surface
area.
. Allows floor coatings or overlays to bond and adhere
successfully
. Helps level floor
. Smoothes minor imperfection ^top |
|
 |
|
|
14251 Fern Avenue
Chino, CA 91710
Phone: (909) 606-7623
Fax: (909)
606-7685
Toll Free: (877) 870-1090
|
|
|
|
Copyright
© 2003-08 Sunbelt Flooring Inc. All rights reserved. |
|
|
|
|
|
|
|
